Solar Programming with the e-viaris app

Viaris Solar configuration

  1. Follow Initial app setup prior to this solar configuration
  2. Log in to the eViaris app and select your charger
  3. Click the settings icon (a small gear) at the top right of the screen
  4. Scroll down to Installation configuration
  5. Enable the Solar Installation and enter your solar system size in Watts. E.g. A 3.5kw system is 3500watts
  6. Select “Inject” for standard solar systems or “does not inject” for off-grid applications
  7. Select if you are using single phase or three phase
  8. Select ‘Secondary meter’ as TMC100
  9. Select ‘Measure’ as Solar
  10. Most situations will use the configuration shown in screenshots below
  11. Click Save
  12. Go back to the settings tab and scroll down to power sections
  13. Once in power sections you can set how you would like the operates depending on solar output and time of day. If you need a hand setting up please do not hesitate to contact Charger Stations Australia.

Solar mode: Only uses excess solar once a minimum of 6A output is available

Hybrid mode: Use all the excess solar available as well as additional power from the grid if required to reach the 6A minimum

Network/Solar: The vehicle will use the full amount of power available from the grid and solar system

1 of 2